1
2
Rack Installation
Installing and Removing the Rails (round-hole racks)
Position the left and right rail end pieces of the sliding rail labeled FRONT facing inward and orient each end piece to seat in the round
holes on the front side of the vertical...
More
1
2
Rack Installation
Installing and Removing the Rails (round-hole racks)
Position the left and right rail end pieces of the sliding rail labeled FRONT facing inward and orient each end piece to seat in the round
holes on the front side of the vertical rack flanges (1).
Align each end piece to seat the pegs in the bottom hole of the first U and the top
hole of the first U (2).
Engage the back end of the rail until it fully seats on the vertical rack flange and the first “tooth”on the latch locks
in place.
Repeat these steps to position and seat the front end piece on the vertical flange (3).
To remove the rails, pull on the latch
release button on the end piece midpoint and unseat each rail (4).
Installation et retrait des rails (racks à trous ronds)
Placez les extrémités gauche et droite du rail coulissant portant la mention FRONT vers l intérieur et orientez chaque extrémité
pour qu elle vienne s encastrer dans les trous carrés de la partie avant de la plaque de montage vertica
Less